QUINDOS - Globoid (double enveloping) WormMTW-510-WGL-001
Inspection of Globoid (double enveloping) Worms on a Leitz Coordinate Measuring Machine.
QUINDOS Globoid Worm provides the tools for the inspection of globoid (double enveloping) worms on a 3D Coordinate Measuring Machine (CMM). The worm can have single or multiple start, with both left and right hand lead.
The tooth flanks of this type of worm are manufactured by an inclined rotating plane (grinding wheel) or by a straight sided skinning cutter.
The tooth flanks of this type of worm are manufactured by an inclined rotating plane (grinding wheel) or by a straight sided skinning cutter.
Leitz Globoid (double enveloping) Worm Inspection Technology: fast, precise and cost-efficient!
- Easy operation due to automatic generation of the moving path and all required probing points and scan lines, including stylus changes, for the Coordinate Measuring Machine.
- With QUINDOS software Globoid Worms can be measured in vertical as well as in horizontal position. A clear advantage when it comes to large, long double enveloping worms.
- With a Leitz Coordinate Measuring Machine a rotary table is not required. Therefore several globoid worms can be mounted on a pallet and measured in one go. This results in a much higher throughput compared to a conventional worm or gear measuring machine.
- The evaluations are similar to those of a cylindrical worm.
Due to the usually tight tolerances of globoid worms, only a high precision Coordinate Measuring Machine with a small probing error P and scanning capability (i.e. Leitz PMM-C) should be used for such measurements.
