QUINDOS Straight Bevel GearMTW-510-SBL-001
Inspection of a straight bevel gear according to DIN 3965.
With this QUINDOS package the measurement of straight bevel gears can be done on a precision 3D Coordinate Measuring Machine without a rotary table. Therefore many of such parts can be mounted on a pallet and measured without the supervision by an operator.
Due to this a 3D Coordinate Measuring Machine (CMM) equipped with QUINDOS Straight Bevel Gear software can achieve a much higher throughput than a conventional gear inspection system.
Internal straight bevel gears, e.g. dies, moulds or electrodes can also be inspected.
Leitz Straight Bevel Gear Inspection Systems: A fast, precise and cost-efficient alternative to a conventional gear inspection system!
The following features are included:
- Automatic generation of the moving path and probing points for the 3D coordinate measuring machine.
- Generation of a point grid on the master flank using the gear parameters.
- Inspection of the flank topography with various evaluation methods.
- Runout and pitch
- Profile and flank deviations.
- Establishing a new coordinate system by best-fitting the actual flank to the nominal flank.
- Calculation of the cone apex position.
- Establishing the optimum assembly position
All evaluations are activated by simple mouse clicks.
